Description
-
Description
Fine-tune your car's Center of Gravity (CoG) and optimize performance and stability. Includes four 1/2 oz (14.1 g) screw-in Tungsten CoG Weights. Use weights individually or as 2 to 4-unit sets. Screw-in and adjust with an Allen wrench.
Weights are 3/4" in length, tip to tip, and 3/8" in diameter. Use a 23/64" size drill bit when drilling a hole for weights in the car body.
Patented Product
-
CoG System
-
Safety Warning
WARNING: Choking Hazard!
Small parts. Not intended for children under 3 years. Adult supervision required.
AVERTISSEMENT: Danger d’étranglement! Petites pièces. Pas recommandé pour les enfants de moins
de 3 ans. Supervision d’un adulte requise.
-
-
I purchased the P362 Funnycar Pre-Cut Design car body and I do not want to place the weigths on the bottom of the car. Could I drill holes in the rear of the car and insert weights there? If so, how many weights would I need?
Yes, holes can be drilled into the rear of the Funnycar Pre-Cut Design. Round Weights (P350) and Tungsten Cylinder Weights (P3914, P3915) fit a 3/8" cavity and Tungsten CoG Weights (P3918, P3919) fit a 23/64" cavity. The amount of weight needed will depend on your local race rules.
- I am looking at your Stealth car and wondering if the weights fit in the holes drilled in the back. What weights do I need?
- What is the thread size of the Tungsten CoG Weights?
-
I purchased the P362 Funnycar Pre-Cut Design car body and I do not want to place the weigths on the bottom of the car. Could I drill holes in the rear of the car and insert weights there? If so, how many weights would I need?
